italiano

RIGID POLYURETHANE CAST MATERIAL

General Agent: Vanio Tessaro - via Bongioanni, 118 - 31044 BIADENE di Montebelluna - TV - Italy - tel. +39 0423 600350
fax: +39 0423 600350 - cell. +39 338 678 2860 - e-mail: vaniotessaro@orthotics.it

info:

HOME

PRODUCTS:

Foam kits for ski and ski
mountaineering boot liners

Foam kitsClassic polyurethane
foam-kits.
50cc. dispenser ratio 2:1Two component polyurethane
foam cartridges
50cc. dispenser ratio 1:1Two component silicone
gel cartridges
Foaming instructions How to make a
good foam liner.
Cast material

Cast material.

Shaped gel

Polyurethane
gel padding.

Heat sensitive
selfmolding material

Heat sensitive selfmolding materialHeat'n'fit heat
sensitive selfmolding
material.
Heat sensitive selfmolding orthotics
Heat'n'fit heat
sensitive selfmolding
orthotics.

Ski-boot liners:

Foam ski-boot linerFoam liners.
Selfmolding inner boots Selfmolding
Thermoflo liners.
Valid HTML 4.01 Transitional

POLYURETHANIC TWO COMPONENTS CAST MATERIAL


The finished piece is absolutely rigid.
Thanks to its low shrinking coefficient it can be used to make casts in the orthotic, dental and prototyping fields.

Cast material kit

Kit of gr. 1.300 in the right ratio.

Cast material kit

Kit of gr. 8.000 in the right ratio.

Foot print

This is a foot imprint. The cast matrial is poured in it and the perfect foot copy is obtained. The orthotic is then built up. This proceeding is well known by orthopedic tecnicians.

Foot cast

This is the cast obtained with the above imprint. It is absolutely rigid, strong and elastic too, therefore it can be used for vacuum forming.

Prototype

This is another example. Many different kinds of casts can be obtained.